Home | Order | Installation Instructions | Contact Us |
SwitchPass Installation Instructions |
|
IMPORTANT!!When using adhesive strips, all surfaces must be clean, dry and warm. Press and hold firmly for 15 seconds. For your used Toll transponder, remove and discard existing adhesive strips from rear of transponder and windshield. Using two of the supplied adhesive strips, attach transponder to mounting plate as shown in Fig. 1. For your new Toll transponder, use the existing adhesive strips on the rear of the transponder and attach transponder to the mounting plate as shown in Fig. 1. |
|
 |
|
 |
|
|
|
|
 |
|
|
|
|
|
|
© 2004 J2 Designs, Inc. All Rights Reserved | SwitchPass is not affiliated with any Toll Pass Authority |
|
|
Home | Order | Installation Instructions | Contact Us |
:Made in the USA